Unepoxy Plus is a modified epoxy bottom paint that dries to a hard, abrasion resistant finish. Resistant to algae, barnacles, grass, zebra mussels and other fouling, Unepoxy Plus is a good choice for boaters who wisha single-season, hard antifouling paint at a moderate price. Recommended for low to moderate fouling waters, Unepoxy Pluscan be applied to fiberglass, wood and properly primed steel hulls. Do not apply to aluminum hulls. Offered in Red, Blue,Black and Green. Key Features Hard, smooth finish High Copper content fights marine growth Apply over most other antifouling Withstands trailering, beaching, and season-long use Physical Data Type: Modified Epoxy/Rosin Finish: Flat Available colors: Red, Blue, Black, Green Components: 1 Curing mechanism: Solvent Release Solids by weight:(Theoretical): 74 +/- 2% Solids by Volume: (Theoretical): 45 +/- 2% Coverage: 400sq.ft./gal. VOC: 490 g/l max. Active ingredients: 45.7% Cuprous oxide Flash point: 116F (SETA) Application Application Method: Brush, roller, airless, or conventional spray Number of coats recommended: 2 Dry Film Thickness: 2 mils Wet Film Thickness: 4.8 mils Applicator: High-quality short nap roller (maximum 3/8” nap) Application temperature: Min. /Max. Range: 40 F. Min/90F. Max Thinner: Special Thinner 120 model 249961; Spray: 121 Spraying Thinner, model 249995 Drying times (Hours) Drying @40F @70F @90F To recoat 12 hr. 6 hr. 3 hr. To launch 24 hr. 16 hr. 8 hr. *The above dry times are minimums. May